VIP 912

Diamond wire machines


Special machine properly studied and manufactured to cut big blocks, boulders and benches, when diamond wire speed adjustment is required.
An inverter device is used to control and constantly adjust the diamond wire speed from 0 to 40 m/sec., according to the type of stone.
The combination with the automatic feeding system by means of “supercard” or inverter, allows a very accurate management of the cutting tool and a very smooth and precise movement of the machine on the rails. It is possible to make two parallel cuts 170 or 200 cm wide and a complete rotation of 360° to cut on any angle, by means hydraulic device.
The same device allows to make horizontal cuts at ground level without the use of any auxiliary accessories.

Technical features

VIP 912

Main electric motor power 37-45-55-75 kW
Starter Progressive / Inverter
Wire tension Automatic controlled by supercard
Diameter drive wheel 800 – 1000 mm
Lateral movement of cutting head 1,70 – 2,00 m
Flywheel rotation 360°
Linear wire speed 0-40 m /sec
Length of rails 2-3 m

Machine with inverter

Main electric motor power 45-55-75 kW
Starter Progressive
Linear wire speed 0-40 m/sec